What are the Safety measures in central chiller plant?
Explain them?
- 22 Answers
- 60900 Views
- Carrier, CPIC, HSL, JLL, I also Faced
- E-Mail Answers
Answer Posted / chandrakanth
1.High presser
2.Low pressure
3.Oil pressure
4.Anti Freezer
5.Water Flow Switch
6.low oil temprature
| Is This Answer Correct ? | 16 Yes | 3 No |
Post New Answer View All Answers
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
What is the unit of attenuation?
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
What is the end effect of linear induction motor ??
how r charge carriers produced
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
If o/p power is doubled by how much does the sound increase
what is the star delta connetion and how can do it a three phase motor with control witing with picture
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
Why auxiliary transformers are not connected in parallel in primary stations?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
how are reversing the direction of dc motor
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
