Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between profibus and modbus communication
- 2 Answers
- 15601 Views
- GMR, I also Faced
- E-Mail Answers
Answer Posted / nirav
Modbus - for connecting differnent make plc data to dcs.
Profibus - same make.
| Is This Answer Correct ? | 2 Yes | 7 No |
Post New Answer View All Answers
How to check vortex flow meter is in good condition while we do not having calibration setup?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Draw bode plot of any transfer function. Why is plotting bode necessary?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
How to calibrate Toxic gas detector?
How many are the types of instrument cables in terms of No. of pair.
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
In turbine what does term CDP, NH, HSSOC means.
Draw a group of instruments interlocked to a Pump & Motor?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
How to measure the dust in chimney(spm)?
What are the types of control valves available
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
