Interested to Buy Any Domain ? << Click Here >> for more details...
where AVR is connected in power plant.
- 7 Answers
- 13175 Views
- ABB, Saudi Red Bricks, I also Faced
- E-Mail Answers
Answer Posted / jeyapal
AVR is actually a PID Controller operating on a set point ,receiving a feed back sample of output voltage of an alternator and comparing with set point.Maintains output voltage and power factor by regulating the excitation level.Construction looks very simple in the form of a printed circuit board located just on the alternator or at times inside switch board panel with a cable run to the generator.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What do you mean by pull of electromagnet?
different aspects of voltage stability
what are the possible reaons & remedies if resistance of NGR getting heat up
mccb service sittings be done?
WHY THE COLOR OF OUTDOOR TRANSFORMER IS BLUE ONLY???
Ac generato how produce power I need for camplet defination
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
Differentiate between digital phase converter and ordinary phase converter.
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
how indusrial diesel generator work
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
