Interested to Buy Any Domain ? << Click Here >> for more details...
Can we loop AC neutral wire with DC neutral wire?
- 5 Answers
- 10696 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / s.r.nalawade
1.In AC circuit there is 'NEUTRAL' point where as in DC circuit the negative terminal is always connected to battery negative.
2. Consider example of Diesel generator. Battery is used for giving start command to starter motor through solenoid. Same battery is used for configuration of RUN/STOP command. Digital switching inputs like low oil pressure, high coolant temperature, remote start/stop are active low. i.e when battery negative is activated, generator controller will respond immediately.
3. Also there is main AC alternator coupled with engine. L1,L2,L3 & neutral are four terminals from alternator.
4. If AC neutral & DC negative is kept common, then unbalance neutral current will interfere with DC negative. Also, you will get line to neutral voltage (240V AC in case 3 phase 415V, 50 Hz system). Imagine the adverse effect of such a high potential on controller digital inputs. Also, as engine block, mounting skid & alternator body & battery negative terminal is interlinked, it will cause electrical shock to operator in contact with generator. Therefore AC neutral must be isolated from DC negative.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is the efficiency of thyristor
what maximum range of star & delta in hp or kw ?
WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB
Explain about 3 phase motor fault current calculation with examples?
What are the effects of electrical faults?
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
what is capacitor voltage transformer?? how it is different from potential transformer?
1.What will be stored in online ups EPROM IC?
What is called limb of a transformer?
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
How is the connection of the tap changer on the HV side been made?
what is subtransient , transient and steady stateac components
Dyn1 transformer vector group testing how to do
we specify current in case of feeder but in case of distributor voltage, why?
Difference between Lugs and Thimbles
