what is the difference between RS 232,RS 485,RS 422, how
they different from each other
- 15 Answers
- 42535 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / amit
RS232
1. single ended unbalanced line transmission
2. prone to noise
3. difference in ground level between T and R leads noise
4. Distance 50 Feet
5. Speed : 20 KBPS
6. Full duplex
RS422
1. differential ended balanced line transmission
2. no noise problem
3. Distance 100-4000 Feet
4. Speed : 100 KBPS to 10 MBPS depend upon distance
5. Full duplex/half duplex depend upon design
6. Point to point/ multidrop
7. Single transmitter and Receiver up to 10
RS422
1. differential ended balanced line transmission
2. no noise problem
3. Distance 100-4000 Feet
4. Speed : 100 KBPS to 10 MBPS depend upon distance
5. Full duplex/half duplex depend upon design
6. 32(max) transmitter and Receiver up to 1032
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what does it mean an active front end in vfd plz explain it briefly
What is the purpose of bypass valve across AS valve.
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
Explain why use mmwc unit?
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
how to calculate the total flow in square root
what is thermo coupler and how it works
which type of filter gives the constant phase characteristics?
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
How to work togather like sov,limit switch,proxy switch and booster in xv
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
