What are difference between automatic and manual control system?
Answer Posted / elibariki
automatic control system is the closed loop system that requires no operator e.g Automatic furnace temperature system
Manual system is the system that requires an operator
Is This Answer Correct ? | 15 Yes | 7 No |
Post New Answer View All Answers
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Question on maha cement
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
What is loop1 and loop2 in MTS LT?
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
defination of radial vibration?
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
Calibration procedure for water rotameters
What is hp & mp seperator .& what is its working principle ?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
what is a half wave, full wave, and bridge rectifer.
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
can anyone guide me how to get any of the previous year GAIL question papers? are they available? 0n 2nd august i have to take the written test.
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.