what is the difference between plc and pc?
- 5 Answers
- 36125 Views
- ADI, NFCL, Wipro, I also Faced
- E-Mail Answers
Answer Posted / shamsher
plc comes with no. of input output modules and control various field devices while pc dont have enomorous i/o.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Decibel.
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
What is standard procedure of manual mapping in Radar type level transmitter?
What do you know about gail?
what is span value and zero ? and how set ?
Explain operation of Haskel pump.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What are advantages and disadvantage of the ac supply load cell?
What is the differerence between hysterisis and linearity.
how do we commission inergen system?
you are on site,the plant trips,you are approached by operations,what do you do?
