Interested to Buy Any Domain ? << Click Here >> for more details...
how many types of threads are used in mechanical industry
- 18 Answers
- 63742 Views
- PMI Engineering, QAFCO, Steel Plant, Tata Motors, I also Faced
- E-Mail Answers
Answer Posted / kanwar pal singh
Normly use the thread in machenical industries are in metric and width worth.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the advantages and disadvantages of air refrigeration system?
What is periscope?
How can you identify mild steel, cast iron, and high carbon steel?
What are the things to do when approaching the port?
What is the meaning of less pumping in AC
please give me production full form
plz send me the aptitude test paper for hpcl.
Why would some industries select pneumatics over hydraulic?
where can i get railway junior engineer(mechanical) previous years question papers?
what is the basic optimal difference among isothermal,isentropic and adiabatic processess( with charts of each)??
What are the items to inspect after cylinder liner is pulled out
Dear sir-I WANT LAST FIVE YEARS RRB-CHENNAI QUESTION&ANSWER PAPER IN J.ENGG(GRADE:II)-MECHANICAL ENGINEER
where can find the information on 2R manipulator?and wat is the history of this 2r manipulator?
What is Rig floor..?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
