Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kingshuk dey
Digital signals: They are wither ON or OFF state. That is 0 or 1. Like if a lamp is glowing or not.
Analog signal is a range of values that lie between ON and OFF. Like the position of gate between the "OPEN" and "CLOSE" position. Like, 45 degrees open. So the signal is between 4 to 20 mili-amps normally (4 amps is FULLY OPEN and 20 amps is FULLY CLOSED). 4 amps corresponding to 0% and 20 amps for 100%.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
how does ELR works? explain
how to generator maintenance (A Check, B check,Etc)
What is mean by Sensitive Earth fault & what are the effects
What are the electrical engineer roles and responsibilities in chemical plant?
On what cycle does thermal power plant operate?
what parameters should we check to reduce the power bill
the problem faced on star or delta winding connection??
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
why does rotor rotets?
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
Usage of flywheel diode in relays
what is Insulation monitoring device. where it is used? (in switchgear room or control panel or in field equipment)
How to do maintenance of transformer feeder.
Which do you think is the most significant cause of energy loss in a factory?
