Why shunt Generator is not recommended to start at ON LOAD condition???
- 3 Answers
- 3169 Views
- I also Faced
- E-Mail Answers
Answer Posted / prathamesh munj
Because its starting torque is less
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why is ignitor used in sodium vapour lamp
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
What are the differences between single phase and three phase?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
how brushed dc motor operating ?
What are the different losses In a de mac1une'! t.xplam
How phase to phase voltage comes 440V.
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
who can measure the size of power cable?
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
how to select correct size of power cable for inverter duty motor
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
