Answer Posted / mukesh vaghela
we use DG set for generation of AC supply when AC supply is not available. We use DC supply of Battery for starting of DG SET only.....
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
What is meant by stator?
What are the applications of autotransformers?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
Define filter?
one split ac how can told of this ac which Tr tell me us
give me a clear defination of inductance,and how can u calculate inductance of a motor
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
What is the diff. between single compression and double compression gland
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
Define phase cross over?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what is JE exam?
what is the correct format to create a resume for interview??