If one lamp connect between two phases it will glow or not?
Answer Posted / alok
If phase to phase voltage is up to the thersold voltage of Lamp it will glow, A voltage greater than thersold voltage will damage the Lamp
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
explain working principle of earth leakage relay
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Explain cos(theta) and Sin(theta)
Difference between control junction box (cjb) and power junction box(pjb)?
how to generator maintenance (A Check, B check,Etc)
how to get bearing & winding temperature of an induction motor?
Whether it is possible to measure energy at the input of rectifier transformer (12 pulse with very high odd harmonics)
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
How to select the proper VSD to operate high inertial load
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.
what kelvin's law ?
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
what percent do you derate your copper wire when you change from copper buss to copper wire
What is a surge supressor why its is used in synchronous generators