Interested to Buy Any Domain ? << Click Here >> for more details...
What does OHB stand for in specifications for circuit
breakers, especially found in SF6 circuit breaker?
- 1 Answers
- 6266 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhishek
OHB circuit-breakers are gas insulated circuit-breakers for outdoor installation. They are used in power distribution for controlling and protecting lines, substations, transformers, rectifier units, capacitor banks, etc. Thanks to the autopuffer breaking technique, they do not generate operating overvoltages. This means they are also highly suitable for retrofitting, where the plant insulating materials may be sensitive to dielectric stresses.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is a signal flow graph?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
What is warm / cold start of HT motors. How many warm start & cold start are possible in a day?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
what is fault level of power system ?
I am EEE student i want to improve my core side skills.how cn i approach it?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
how to calculate the no load current in transformer?
What do you understand by external characteristics of a d.c. Generator?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
advantages and disadvantages of inverse definite minimum time RELAY
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
