Can you any explain about active,reactive and apparent power
in power system with example.
Answer Posted / somann
Active power means ,what the power we are using,_,that is VICOS¢(W)
Apparent power means ,which is in transformer_that is , VISIN¢(VA)
Reactive :VISIN¢(VAR)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to design the heater in temperature control unit to heat 50KL of water?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what will happens if one phase is missing for 33/11kv power transfomer and why?
Is the theorem applicable to ac sources?
What are the operation carried out in thermal power station?
what r substations?what r there work?why voltages r incresed and then reduced during distribution of power
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
How will polarity test of Dy5 Transformer ?
i want to know that how the height of Ct ,cvt ,LA calculated on the basis of creepage distance
What is difference between YNyn0 and YNyn ??