Interested to Buy Any Domain ? << Click Here >> for more details...
what is the meaning write of AC1,AC2,AC3 .....power contactor
- 7 Answers
- 35612 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / abdul rehman khalid
AC1..This applies to all AC devices (loads) with a power factor of at least 0.95 (cos phi greater than or equal to 0.95).
Example of use: resistive load, heating, distribution.
AC2..This applies to squirrel cage motors where breaking occurs while the motor is running.
Example of use: all squirrel cage motors, lifts, escalators, conveyors, bucket elevators, compressors, pumps, mixers, air conditioning units, etc.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
how to wiring it with contactor and timer together
what is alluminium arm in ab conductors
how to increase senstivity of ct
What should be setting for alarm,tripping and cooling fan on for power transformer's oil temp. and winding temp. indicator?
What it the purpose of parallel phasing transfomers??
we need a ntpc previous papers
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
Give two basic speed control scheme of dc shunt motor?
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
what is the difference between switchgear and circuit breakers and is there any difference between outdoor and indoor switchgear and circuit breakers , and how would you differentiate between switch yard and substation and grid station . thanks
Do closed loops systems require manual input?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What are the reasons for the parallel operation of transformers?
