how eddy current loss in probe and induced gap voltage accros probe trip and shaft
- 1 Answers
- 3594 Views
- Reliance, I also Faced
- E-Mail Answers
Answer Posted / dinesh
no
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
How u measure the massflow in orifice flow measurement techniques
how to calibrate and troubleshooting of leveltroll?
How is work 5/2 sov?
What is force balance principle? State some of its’ advantages.
How can you add value to this Industry if offered the job?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
List three types Level Switches with their working principles
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
What are different types of cable?
What is megering????
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
How to calibrate level transmitter with use of HART?
