Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kranti1986
it varies with the application and design. Normally we use 12mm, 1/2", 3/4", 1"
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
typical loop drawing of a simple feedback control comprising of one transmitter and one control
How many are the types of instrument cables in terms of No. of pair.
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
What is the diffrence between ff tx and non ff tx
why orfice is not used for main steam flow calculation
steps for installing orifice plate?
which type of filter gives the constant phase characteristics?
what is cems analyzer explain with principle and drawing ?
principle of dead weight tester ?
what is the reset offset and control system in instrumentation
Difference between ultra sonic flow meter
What is zero elevation and zero suppression?
