Interested to Buy Any Domain ? << Click Here >> for more details...
Why electrical engineer use Cu Strip for transformer
neutral why not GI Strip? What if we use GI instead of Cu
does it affects the transformer performance.
- 7 Answers
- 18498 Views
- I also Faced
- E-Mail Answers
Answer Posted / bala
If we use GI strip instead of cu. The benefit is cost and also GI resist the fault current than cu, so the level of fault current Is slightly reduced than using cu. ...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the classifications of oscillators?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
How to synchronization will be done between two DGs ?
Difference between shunt, PMG and AREP excitation. Which is the most reliable between PMG and AREP.
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
How i can decide that HVDC line is best for transmission.
How to calculate multiplication factor in kva example 500kva ans pls ?
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
how the testing of protection CT Testing done through Primary injection kit please describe in detail procedure...
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
how the characterstics of control valve being done
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
can u please mail me the syllabus for GET exam for damodar valley corporation?
