Interested to Buy Any Domain ? << Click Here >> for more details...
Why we are using PLC instand of DCS in ESD System? can u
explain any one?
- 2 Answers
- 5563 Views
- I also Faced
- E-Mail Answers
Answer Posted / manan2347
Because of the scan time.
the scan time of DCS is generally of 100ms to 1 sec. where scan time for PLC ia 10ms.
we want quick action in case of any emergency for that we are using PLC in ESD system.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
Gas equation
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
what is function of SCADA , and how is it work, explain with difination
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Where is wet leg is used?
What is voltage regulator?
what is interlock system and why we use of this?
protection relay watchdog contact operation?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
What is Erosion in a control valve?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
