Interested to Buy Any Domain ? << Click Here >> for more details...
i am electrical engineer i cant get job in pure electrical
industry ,but i got job in instrumentation field whether
there is good scope for me, as i am fresher i m not well
with the industrial trends so any experienced engineer pls
reply me
- 2 Answers
- 4073 Views
- I also Faced
- E-Mail Answers
Answer Posted / engr. nazmul nahid
If u r in a complex heavy industry, don't miss your chance to by joining as an instrumentation engineer. In power plant & in Oil refinery Electrical & Instrumentation is a must needed post. And if u r in instrumentation field, it does not means that u only learn instrumentation; rather in side by side u will also learn electrical systems quickly.
I'm also E&I engineer & I know same thing that known by an Electrical Engineer.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
. How to calculate the Short Circuit Impedance in Transformer? How to calculate the Short Circuit Impedance in Transformer?
l&t switch FN 63 handle position can we change
what is the relation between size of the anteena and wavelenghth of radiated wave
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
plz tel me syllabus and exam date 4 jr executive engg (electrical)
what is lrs tank water resistance.
What is making & breaking current ???
what can be the causes of capacitor start motor having a higher current that its actual
what is the difference between capacitive and resistive voltage divider?
how to synchronize 3 phase slip ring induction motors of different ratings.
What is the principal of motor?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
what is high and low cut off voltage of BB and DG at SPS????????
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
