Answer Posted / sree
Voltage regulation is given by an expression (no load voltage- full load voltage)/no load voltage
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
list of tests to be carried out at manufacturers end while purchasing a step up transformer of 11kv to 66kv ,2MVa Capacity.
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
What is the minimum underground tank size capacity considered for firefighting purpose?
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
how to calculate the formula of cable size if motor kw is given
what is the purpose of high speed earth switch in gas insulated substat
How to calculate wire length,size & current? ( related to control panel)
can someone explain that how the speed of the protection system affects the fault level calculation?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
what is interfacing in computer studies?
how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.
When lag/lead/lag-lead compensation is employed?
what are inherent currents?
