Why ct secondary is not kept open while primary charged. Answer in terms of ct parameters.
- 4 Answers
- 5172 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / vipin singhal
when secondary is open then in primary flows very large current which burn the winding of the core.
| Is This Answer Correct ? | 8 Yes | 4 No |
Post New Answer View All Answers
given data are load current & power factor cable core size? plz any one update the calculation formula
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
what is the IS foe lightning arrester?
What type interview questions ask in Electrical technicians
How a band pass filter is constructed?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
How to select transmission line type (i.e. 11kv or 33kv) for new established industries
What do you mean by dependent and independent voltage sources?
What is the size of a 60 watt and 80 watt tubelight?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
What is the difference between isolators and electrical circuit breakers?
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
How efficiency of thermal plant can be improved?
sir, Is their any measuring unit of knoking? please explian?
Why is better to have a minimum ceiling voltage of 250% than 160%?
