Answer Posted / senkathir
relay can uses low power load.contractor can uses high power load
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is process analysis?
How to check DC Motor & SERVO Motor?
Can you calibrate, troubleshoot and repair instruments? Which tools do you use for the same?
what is Automated smoke test suit? and why we use thah in QTP??
What are the various methods for calculating the cost?
What is process planning?
why we give dedusting steam in feed gas coils in convection section of primary reformer?
What is the difference between preventive-maintenance and periodic-maintenance?
what is the g.s.t rate of m.s. perforated sheet
where is floating bearing located?
What is different between preventive maintenance and maintenance?
What is load line in control valve?
Let’s say we live in a country that gets very cold, in Northern America / Europe. In winter, we monitor the ouside temperature, so that heaters can be switched on, inside the house. The idea is that, the colder it is outside, the warmer it should be inside. The heating side of things is just a heater that is either switched on, or switched off. Just from the information that has been given, please discuss this matter in depth. Provide reference to OPEN / CLOSED loop control, FEEDFORWARD / FEEDBACK control and MODULATING / ON_OFF control raised in the discussion.
what is dc injection braking?
Sir, we are manufacturer of splitter machine. we joint two knifes with welding electrode, BEST ARC, and ADOR, Grade E6013. but the time of welding the welded area comes to wear, what meterial(Electrode)is suitableto our requirement.this knife is press with Hydraulic operation.
