Interested to Buy Any Domain ? << Click Here >> for more details...
According to ohms law voltage proportional to current, then why should current rating is low with high voltage rating in transformer?
- 5 Answers
- 8082 Views
- KEC, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Ohms law applies only to ' only resistance ' circuits . The ' No- load current' of a transformer is not equal to Voltage / impedance , but only a fraction
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
I am EEE student i want to improve my core side skills.how cn i approach it?
What is the reason that the humming sound is coming from the induction furnace panel?
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
What are IR values and what it should be for coil and for insulator
What is nyquist contour?
give me atleast four differences between circuit and network
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
What are the different types of dams?
What is difference between YNyn0 and YNyn ??
IN dc capacitive reactance is??
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
how to avoid Saturation in C.T?
How the over load setting for HT Motors calculated-provided in Numerical Relay
