Interested to Buy Any Domain ? << Click Here >> for more details...
How to reduce current flowing in neutral due to unbalanced load conditions in a three phase system.
- 1 Answers
- 4261 Views
- IOCL, wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / ayan deb
To arrest the unbalanced current flowing through the neutral, we will have to Load Balance all the 3-Phases. which will check the flow of unbalanced current.
| Is This Answer Correct ? | 4 Yes | 9 No |
Post New Answer View All Answers
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
At what speed 1 HP motor can run an electric car of weighing 400 kg?
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
What if the difference beween internal and exrteranal LBB?
what is 30-phase of transformer
What is meant by RVT and NDR ? expansion and details of it
Any one can explaination about calibration with rotating sub standards?
What are the advantages & disadvantages of a group electrive drive?
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
what is the meaning of 0.5ohm Resistance
can you plz send l&t aptitude questions if available its urgent plz plz plz
Why control of DC motor is simpler?
