Interested to Buy Any Domain ? << Click Here >> for more details...
According to ohms law voltage proportional to current, then why should current rating is low with high voltage rating in transformer?
- 5 Answers
- 7679 Views
- KEC, I also Faced
- E-Mail Answers
Answer Posted / dip
plz suggest
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
How can two 3 phase transformers of same KVA and Voltage be connected in parallel?
Single line digram for 11 kV to distribution use go,la and do
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
Name the test signals used in control system
What is the importance of earthing?
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
