Interested to Buy Any Domain ? << Click Here >> for more details...
What are types of encoders?
- 19 Answers
- 91805 Views
- ITC Infotech, UFO, Wipro, I also Faced
- E-Mail Answers
Answer Posted / sethupathiraja
1. rotary encoder
2.linear encoder.
These two are had
a.incremental
b.absolute
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
how to increase senstivity of ct
Do closed loop systems require manual input?
How to check the Bushings of the transformer?
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
what is the saturation point of crgo lamination.
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
what is p.s impedance measurement test in earthing transformer?
Why Stabilising Resistor used in REF circuit ?
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
what is destructive and non-destructive testing of welding
how to enter inverter parameter? without manaual?
what is the value of combined earthing in general electrical circiut?
