Interested to Buy Any Domain ? << Click Here >> for more details...
why dc motor runs slowly when dc supply is given?
- 2 Answers
- 5348 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If the voltage is normal ,the shunt motor runs slowly as the field current is kept at maximum value while starting .
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what are inductive and capacitive voltage transformers.what are their applications
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
if i am in front of transmission line how to know that current direction without any equipment
hai friends i have BSNL JTO exam on next month so if any body have model question paper or give preparation tips to my mail id kumar4486@yahoo.co.in this will helpfull for my future .plz & thank u by kumar
How many points does a Circuit can have?
what are the applications of PLC?
how to calculate
gas turbine genrator reactances
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
what is the maintaining Cf in UPS.
