Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the minimum and maximum ohmic value for
earthing?
- 2 Answers
- 5901 Views
- I also Faced
- E-Mail Answers
Answer Posted / engr. rohail joses
Normally the Earthing Resistance value while designing Earthing Systems for Power Plants is kept below 1 Ohm, this value ensures Step and Touch Voltages not acceding their safety limits.Also the GPR (Ground Potential Rise) during Lightning Discharge, Line to Line and Line to ground Faults for less than 1 Ohm Earthing Resistance is also confined within its safe limits and Earthing System is with less than 1 Ohm Earth Resistance becomes fully capable to dissipate/ handle this Destructive phenomenon. This is as per IEEE Standard [IEEE Std 80-2000]. However for small substations and Industries Earthing Resistance value of less than 5 Ohm is also acceptable.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Yazaki india pvt ltd interview questions qurey related
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
diff b/w normal grounding and resistance grounding
How test for Ddo vector group test condition?
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
how we arrange the hv side with delta connection in case 33/11kv of transformer.
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
what is the purpose of shading ring or shading coil in electrical equipments.
what will happen if the prime mover on the field excitation of the on-coming generator fails?Explain.
Why squirrel cage motor can only use with low starting loads ?
what happened when we supply a dc current in dc motor?? can it worked properly?
How can we measure earthing resistance test (Earth meggar) of Transformer neutral pit while in live condition?.
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
What are the factor to be consider for CT selection in 132kV substation?
