Interested to Buy Any Domain ? << Click Here >> for more details...
Lube oil pressure transmitter local it's showing 9.8 kg/cm2 but dcs side it's showing 9.26 like that what is the reason?
- 3 Answers
- 5758 Views
- Edac, I also Faced
- E-Mail Answers
Answer Posted / karthisampath
It may be forced
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
How the warning lamp of a charging-system is activated ?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Galvanizing.
What is the difference between mmwc and mmwg?
what is scale factor of proximitor & unit of the vibration.
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
what is the calibration procedure for transweigh make weigh feeder?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
How works weighfeeders in cement industry? what is the working principle?
how to convert cubic metre per hour to newton cubic metre per hour
How to Calibrate Ultrasonic Level Transmitter in field
can you provide me full detail about instrumentation in ONGC??
what is the procedure of O2 sensor(ABB) calibration?
