Answer Posted / sanjay
Power factor is cosin angle between voltage and current.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why do we use copper cable for HT Supply and why not Aluminium?
Define non-touching loop.
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
What is boucholz relay and the significance of it in to the trformer?
what is th basic difference between a d latch time line and a d flip flop time line???
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
what is the use of the circle diagram
what type of earthing do for dry fissure rock?
What is the estimated total hydropower potential of india?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
c++ write a program to use a fuction call "max"which accepts an intger arrey of size5.as an arrument and return the larger and smallest of the arrey to main without changing. the original changing of the original position of the element of the arrey.
