Interested to Buy Any Domain ? << Click Here >> for more details...
If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?
- 10 Answers
- 16114 Views
- QAFCO, I also Faced
- E-Mail Answers
Answer Posted / jitendra singh
10M to -10000mmwc for below to transmitter position
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
what are procedure of sox-nox calibration
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
What is the use of double seated valve?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies
Why do we have earthing cable in branch cable and shield in the same cable?
why using negative supply for bentley nevada vibration system ?
If we increase only P what will be controller action ?
There are many type of control cable like pair,core,tried, What are defination each one
