Why we are always only used 11 kv. , 22 kv ,33kv in transmission line? Why not use 25, 55 ,65 kv ?
- 3 Answers
- 4505 Views
- Khidmah LLC, Precision Camshafts Limited, I also Faced
- E-Mail Answers
Answer Posted / achal
It has no answer. People say and link it to some equations but for real it has been chosen randomly and now it has became an standard.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Why different Pressure switch used in marine boiler water circulation system
Comment on the working principle of operation of a single-phase transformer.
why high speed tripping relay will be used in tripping circuit why not normal relay
What is thresh hold value of current?
As we know induction squirrel cage motor torque Directly praprortinal to applied voltage in star connection & delta also. If I connect 55KW Motor to DOL starter in load condition does motor withstand the load & what will be the current withdrawn ? motor will not fail ?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
Can i use the B-curve MCB instead of C-curve MCB
How to Calculate KA Rating of Main LT Panel
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
what is the difference between b c d curves on mcb
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
how to protect motor in dol starter having capacity of 30 hp.40 hp?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
How Can You Relate Power Engineering With Electrical Engineering?
