Difference between transmission line and cable?when ever a
large water channel has to crossed it is easier to use
cable then transmission line why?
Answer Posted / achal
Transmission Line is a bare conductor while cable on the other hand has layers of insulation around the conductor.
To cross a Water channel we can use Cable but considering the "Cost" of Cable, Transmission lines are cheaper. Another reason for it is fault finding is easier in over head line than in cable.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Discuss about gear cutting machines.
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
Difference between a pilot wire and a normal conductor?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
What are the advantages and disadvantages of closed-loop control system?
what r the safety measures in UPS ? explain all?
What is the difference between indoor and outdoor transformer
how much flux density of CRNO core
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
Difference between rating factor of cable and derating factor of cable?
HOW CAN YOU CALCULATE PRACTICAL EFFICIENCY OF A ASYNCHRONOUS INDUCTIONMOTOR OF 7.5KW,& MOTOR IS RUNNING WITH AVOLTAGE OF 410 VOLTS,& TAKING CURENT OF 13 AMPS