During shutdown of Steam Turbine,How do we cross the
critical speed?
Answer Posted / sbr
First off all we have to close prds line valve due to prds pre low and vaccume also low that meens condenser pre high in the case turbine was tripped with low vacume after that close the esv. Why turbine shaft free fall in down when ever having vaccume in condenser rpm slowly dicresed even that time shft having some load then we crose the critical speed some vibrations are coming so first shaft free only can crose the critical speed
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why airtel use + 24 volts and other operators use -48 volt
What is LB-SR.
LAPT working in alternator / generator
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
what is the meaning of SST300 V56A in SIEMENS turbine
what's the moog valve
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
can dp type level transmitter work in under vaccum condition
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
explain how the third harmonic content of the magnetising current affects transformer design
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?