Answer Posted / varaprasad inavilli
Cable gland is used for connecting the cables to panels,DB.
It is also called as end terminal of the cable which have a provison for connection to panels,DB(INCOMER AND OUTGOING FEEDERS)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is “pu” in electrical engineering?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?
how you taken aotitude test
what are the application of over current relay?
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
aternator every parts and its working
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
What is the difference between hot and cold loop testing?
how to setting voltage RTCC panel
where rlc series ckt used?
how the inner and outer body is separated in aircrafts?
What is the purpose of using busbar mounting fuse?