what are the CAD software versions you have used?
Answer Posted / shahwez mirza
m using AutoCad 2010. Its a good version
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Does VDF add strength to the flooring apart from preventing water ingress?
how i can tak Quantity of mortar in block work
what is c4x light weight cement blocks
Mention different types of roof systems?
can i make bricks using M10 grade concrete ? and what would be the cost of a brick if we use m10 grade concrete sand and aggregates ??
what is a well
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
how meny typs of renging rod?
what is the proper procedure in conducting a california bearing ratio penetration test on soil on cbr machine?
Power grids in two adjacent states(A&B) are interconnected. Can power grid in state A can be represented by Thevenin Equivalent Circuit. If not explain Why?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
how to calculate the crushing strength of cement concrete paver blocks 100x100x60 mm thich.
what is the specific gravity of rubble in plum concert
What glue is least sticky?
PLS.......... ANY ONE CAN FORWARD ME PREVIOUS QUESTION PAPER hpcl civil engg