d/p flow transmitter LP side give to pressure.what you
geting out put ? how you get(ma)?
- 6 Answers
- 11885 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / imran yousaf
when we apply pressureon LP side only , then there will be some outpur in the form of mA, it does not matter it ll' be either +ve or -ve bcs current have no polarity value.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the procedure of calibration of Load cell?
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
Isometric drawings are generated during _________________ phase of a project
what is scale factor of proximitor & unit of the vibration.
Describe the function of Accumulator into the Pump
what is the procedure of O2 sensor(ABB) calibration?
Why even multiple power supplu r used in instrumentation system?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
Questions on flow meters,few questions on HART protocol,
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
Describe the functions of the Operator Interface including the considerations related to alarming and display layout/configuration/layers.
how is work pressure switch& level switch?what is the principle of this?
