why we use the 4-20 mamp signal used for transmitter.
Answer Posted / amar.sm
NO LOSSES IN 4-20 milli amps or no drop
Is This Answer Correct ? | 4 Yes | 10 No |
Post New Answer View All Answers
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
explain key exchanges in all security modes WPA,WPA2,TLS?
What are the interlocks we have to check during the start up of LP/HP compressor?
What is the use of each wire in three wire RTD
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
How to convert milliampares into flow??
why we are not using the turbine flow meter in the steam service?
ORP sensor working principle?
how to calculate range of level transmitter?
Explain the key components of control loop?
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.