which motor is used in our Indian Ceiling fan -Capacitor
start and run or Capacitor start?
(during repair i saw only one capacitor so it should be
start only)
- 5 Answers
- 15137 Views
- ABB, Bajaj Electricals, Power Grid, Ruchi Soya, Suzuki, I also Faced
- E-Mail Answers
Answer Posted / osama bin amjad
May be its helpfull to u.
Once I have faced the same problem.
u can also search for grundfos starting and running capacitor.
Starting capacitor is of high rating while running has its low value as compare to starting. Beacuse of the reason behind in starting motor required more torque and for its it required high discharge capacitor to start motor and after few seconds when motor comes to its normal rating/running than the other capacitor starts working for normal and smooth running.
therefore we called start and running capcitor as starter and running capacitor.
U can also see the wiring diagram in grundfos motor required starting and run capacitor. Relays or contactors used normally to start and run capacitor.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is an ac motor?
Why reactors use before incoming of ac vvfd drive?
can i use ups power as a raw power for another ups
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
List out the the types of Mounting Light fixture?
Whether power factor should be high or low? Why?
How energy is generated in hydroelectric power plant?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
Do you know what is dry-out test in x'mer
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
Why is water motor not taking the pressure? what is the problem?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
how can you calculate fault level ?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
