what is superbuilt-up area in flats & how it is calculate?
- 5 Answers
- 8331 Views
- I also Faced
- E-Mail Answers
Answer Posted / pramod naik
Super built-up area is the built up area plus proportionate area of common areas such as the lobby, lifts shaft, stairs, etc. The plinth area along with a share of all common areas proportionately divided amongst all unit owners makes up the super built-up area.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how many men days of loburs and masons are requirete for 1 cum,pcc (1:2:4),Pcc(1:3:6) and Pcc(1:4:8) thanking you
How many litres of water used for curing of 1000sqft of slav
why we provide bent up reinforcement bars at l/4 ? if it is because of diagonal shear , how does it acts ?
how many material required for brickbat water proofing of toilets.
What is the difference between undo & redo?
How to identify the vitrified tile and ceramic tile by observation only after executing the job.
Can compresive strength test for concrete at 1 day age possible to carry out? If yes, which IS code describes the procedure for such testing?
what is difference between fluidity and workability also how palsticizer works
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
I have an span length 16 ft c/c
we have a crushing plant and our product is experiencing flakiness and elongation over limit for granite. what is the solution to this problem? how can it be avoided and what to do differently? It is not ok for batching plants
Explain what is zoning permit?
i have boiler of 35 tone and wanted dig out foundation is there any body to help me to carry out calculation for the foundation like
Laying bitumen concrete 40mm thick using 0.1372 cum of 13.2 10mm metal ,0.2387 cum of 10 5mm metal...what did it means please explain me how much cum of 10 mm metal need?
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
