Interested to Buy Any Domain ? << Click Here >> for more details...
Hello Friends do you know this answer of this Question? Which color you would use when there is Somthing not correct or need to change In P&ID? i mean color that use for highlight that need to update in P&ID.
Yellow Highlighter ?
Red color ?
Blue Color ?
Appreciate for your answer.
Thanks
Blue Color
- 2 Answers
- 6004 Views
- I also Faced
- E-Mail Answers
Answer Posted / saif
Yellow Highlighter ?
Red color ?
Blue Color ?
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
How to find out the current of two motors having same power consumption but different RPM?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
Define the difference between a stable versus an unstable controlled system and some of the tools you might use to be able to detect when this is happening and assumptions used for control system application design that could contribute to instability
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
Explain signal isolator
What are advantages and disadvantage of the ac supply load cell?
Identification of ss fittings, pilot valves, relief valve.
Turbidity analyzer working principle ?
what is dc moter.
How to Calibrate Level Switch in field
Define cryogenic?
What is PDS and PDMS ?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
