For backup batteries connection,which method is best? series or parallel ?
- 3 Answers
- 6720 Views
- ABC, I also Faced
- E-Mail Answers
Answer Posted / pundlik wanwe
Series combination is used for the batteries as to get the required voltage. Battery capacity (ampere-hour) shall be of same
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
how can see the ac indoor or out door ac which Tr
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
Why earthing is necessary for any equipment?
Why GRR starts from 60% of motor speed why not less than 60%?
what is static frequency converter?what is the function...of sfc...?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What is the practical way to calculate the cable size for known ampere load?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
How you will determine the volume of oil in a particular Distribution transformer.
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
What is the function of the generator exciter?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
i want wipro vlsi placement pattern please send me
