Interested to Buy Any Domain ? << Click Here >> for more details...
For backup batteries connection,which method is best? series or parallel ?
- 3 Answers
- 7680 Views
- ABC, I also Faced
- E-Mail Answers
Answer Posted / kaushal
For battery backup,it is neccesary to connect battery in series.Because in case of series connection of batteries,
v=v1+v2+.....Vn while in case of parell connection 1/v=1/v1+1/v2+....+1/vn
| Is This Answer Correct ? | 13 Yes | 3 No |
Post New Answer View All Answers
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
surge tank, hrc fuse, earthing transformer, firm power objective type
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
how to calculate the earth fault current
what is ic 01,ic 06 ?is it types of cooling?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
how freewheeling diode improves the powerfactor
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
