Interested to Buy Any Domain ? << Click Here >> for more details...
why do mostly prefer to generate and distribute electricity in 3 phase..not in 4 phase or 5 phase.??
- 5 Answers
- 9335 Views
- BSBK, IOCL, NTPC, I also Faced
- E-Mail Answers
Answer Posted / mahesh
it needs many slip rings, converters,cross arm long increased,cost incrsd,,,,,etc
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
how the inner and outer body is separated in aircrafts?
How is the connection of the tap changer on the HV side been made?
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
What is the difference between grid and off- grid system??
what work will do diffrential realay DG set
Explain mechanical rotational system?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
which connection is safer series or parallel?usually which connection we prefer at home?
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
