Which UPS (inverter) is better and why ?
12 V inverter and 24 V (two 12 V batteries in series)
inverter which is better .........
which has the longer backup
which has the greater charging time
which has the greater discharging time
thank you
- 2 Answers
- 3480 Views
- I also Faced
- E-Mail Answers
Answer Posted / mahato ashok
24 volts is in better ,not in 12+12volt in series use,ups is in uninterrupted power supply and inverter is only converted to dc to ac,ups full sine wave voltage supply.longer back up depend on AH of batteries,
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
where we use the SFU & FSU?
What happens to a motor if it is connected in Delta connection
When and where resistance earthing is used ? How to calculate the time constant for earth fault
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
Explain what is clipper and clamper circuits?
What are protections for dty type transformers
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
In a single how much maximum current and watts using
Why we find the sensitivity for the CT's to check?
What is meant by rotor?
what is meant by impedance & transient protection?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
