Why should we use the igniter in the sodium vapour lamp.
- 7 Answers
- 69194 Views
- ABB, Delphi, Mudhra, NTPC, PICT, I also Faced
- E-Mail Answers
Answer Posted / sidlingu
ignitor is a temperature controller
| Is This Answer Correct ? | 11 Yes | 47 No |
Post New Answer View All Answers
Operation carried out in thermal power stations?
WHY RATING OF VCB NOT LESS THAN 630A
why servomotor motor? where i apply for best output?
what is the VA(Volt-amphere)? define with calculation?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
Why CBCT rating is 50/1A
what kvrah y we need to take the readind of that
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
Why are the laminations insulated from each other?
how to define tell me about self
What is reverse power relay?
why the check zone and main zone are used for Busbar Protn. scheem?
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
