Interested to Buy Any Domain ? << Click Here >> for more details...
what will be the grade of concrete for PCC having ratio 1:4:8?
- 8 Answers
- 18923 Views
- L&T, UIPL, I also Faced
- E-Mail Answers
Answer Posted / vijay kumar nishad
m5
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is Bearing Capacity,How to determine it?
Why are steel plates inserted inside bearings in elastomeric bearings?
what is that one cub metre plaster in cemant and fine sand
How much does it cost for a R.C.C cover slab of size (450mmX 600mmx 100mm) double rf net given in feets using hand mix concrete?
what is right & short method of measurement of slab&beam
manhole chamber having height of 2300 mm and thickness of brickwork is 230 mm and dia of opening covering is 560 mm and bottom length vertical is 1500 mm (1:4) brick masonry and plaster 12 mm on both sides..how to estimate the no bricks used with mortar cement bags and sand for total chamber including plaster.
What is meaning of Canceled/Flat Beam. What is difference between them? Both type of beam can bear same load if size (width)of the flat beam is increases and depth is same as slab thickness? Kindly suggest to me.
what is m30 in concrete tiles
cause of cylinder test failure
Why is the statue of liberty made of copper?
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
Design a rectangular channel.
explain what do you mean by the property development.
why we provide bent up reinforcement bars at l/4 ? if it is because of diagonal shear , how does it acts ?
What is the difference in painting using Roller and Brush? What is the paint consumption difference? As per IS one coat of painting is painting from left to right and top to bottom whether this can be done using roller ( Roller Stick height and feasibility) ?
