Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / liladhar danej
VA BURDEN :
The apparent power of the secondary circuit in Volt-amperes expressed at the rated secondary current and at a specific power factor (0.8 for almost all standards)
knee VOLTAGE :
That point on the magnetizing curve where an increase of 10% in the flux density (voltage) causes an increase of 50% in the magnetizing force (current).
The ‘Knee Point Voltage’ (Vkp) is defined as the secondary voltage at which an increase of 10% produces an increase in magnetizing current of 50%. It is the secondary voltage above which the CT is near magnetic saturation.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
How much load can take a 16 mm aluminum cable 3 phase
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
Explain Circuit Breaker Trip Characteristics in detail.
What is a parabolic signal?
Define cuttoff frequency?
List the time domain specifications.
What is ST and specify its range of voltage.
What is the formula to calculate the no load current of a single & three phase induction motor
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
what is the difference between c power and U power acb breaker
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
