Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / r_vaya
Suppose Transmiter is calibrated at -100 to + 100.
Determining it's LRV =. -100 And. URV. =. +100
Thus in above case :
Range is -100 to + 100
Span is 200
Because,
Span is the gap between LRV and URV
That'swhy (+100) - (-100) = 200 become a Span
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
selection of the zener barrier for the hazardeous area zone 0
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
how to design orifice plate?what is the equation?
What is the procedure of calibration of Load cell?
Programmable Logic control.
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
How to Calibrate Radar Level Transmitter in Field
What is the minimum rating availalbe for weld neck orifice in market?
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
